leviton motion sensor light switch programming

How to Program Your Leviton Motion Sensor Light Switch

Are you having trouble with your Leviton motion sensor light switch? Perhaps you're trying to connect it to your smartphone or tablet, but can't seem to get it to pair. Don't worry, resetting and programming your Leviton motion sensor light switch is a relatively straightforward process that can be completed in just a few steps.

To begin, make sure the switch is powered off. If you've recently purchased the switch and are trying to get it up and running, this may seem like an obvious step, but it's crucial for ensuring your safety while resetting the switch. Once the power is off, press and hold the pairing button located on the side of the switch until the blue light begins to blink. This indicates that the switch is in pairing mode.

Next, open your phone or tablet's Wi-Fi settings and locate your Leviton switch in the list of available networks. You should see a blue light blinking indicating that the switch is in pairing mode. If you're having trouble finding the switch, check that it's powered off and try again.

Once you've located the switch, select it and enter the default password for your Leviton switch. The default password is usually 'Leviton123' unless you have changed it previously.

After entering the correct password, follow the prompts on your device to complete the pairing process. If you're having trouble with this step, refer to the user manual or contact an electrician for further assistance.

Once the switch has been successfully reset and paired with your device, turn on the power at your circuit breaker and test out your newly reset Leviton motion sensor light switch. You should be able to use it like normal again, with the added convenience of being able to control it remotely using your smartphone or tablet.

In summary, resetting a Leviton motion sensor light switch is a relatively simple process that requires powering off the switch, pressing and holding the pairing button until the blue light begins to blink, selecting the switch in your Wi-Fi settings, entering the default password, and following the prompts on your device to complete the pairing process. With these steps, you should be able to get your Leviton motion sensor light switch up and running in no time.

Leviton motion sensor light switch programming